Page 1 v1.0
SDS-1 Phone Configuration Guide
Step 1: Set a Static IP Address on Your Windows 10 Computer
To access the web interface, your computer must be in the same subnet range as the station. There is a video about this on
the
config file download site you were just on
.
1.
Click
Start
, and type
Control
in the search field, then select
Control Panel
.
2.
Click on
Network and Internet
.
3.
Click on
Network and Sharing Center
.
4.
On the left pane, click the
Change adapter settings
link.
5.
Right-click on your
computer’s Ethernet
network adapter and select
Properties
.
6.
Select the
Internet Protocol Version 4 (TCP/IPv4)
option.
7.
Click the
Properties
button.
8.
Select the
Use the following IP address
option.
9.
Set the
IP address
(e.g.,
169.254.1.90
).
10.
Set the
Subnet mask
. (e.g.,
255.255.0.0
).
11.
Click
OK
.
12.
Click
Close
again to close the network adapter properties.
Step 2: Connect the PC, POE Switch, TCIS-2, and Phone
1.
Plug the PC and the Turbine TCIS-2 into the Ethernet POE switch.
DO NOT plug in the phone yet
. Make sure to turn
off WiFi on your laptop
if you can’t access
the TCIS-2 in the steps below.
2.
Allow for about 60 seconds for the Turbine to boot up. The light on the Red call button will be flashing yellow. Now
plug in the phone.
Step 3: SDS-1 Phone Configuration
Network settings
1.
Press the round
Menu
button.
