Zenit Powertools HAG-2011, Инструкция по эксплуатации

Страница: 5 / 8

5
technical specifications
Model HAG-2011
Rated power 1400W / 2000W
Rated voltage 220-240 V
Rated frequency 50-60 Hz
Flow and temperature
regulation system
2 mode heating
Airflow / Air tempera -
ture
---
mode 1 300 l/min/ 380° С
mode 2 500 l/min / 500° С
Air temperature 380°С /500°С
intenDeD use
1. Removing paint
On profiled surface, paint can be removed using an appropriate fitting spatula and
brushed off with a soft wire brush.
2. Cable shrinking
Heat-shrinkable sleeve is installed on the insulation place and is heated by hot air flow.
Sleeve shrinks by 50% in diameter and seals joint. This operation is used for sealing and
repair of damaged cable, sealing of welding points, cable sheathing.
3. Shaping plastic
Thanks to hot air flow it is possible to soften and shape plates, pipes or ski boots.
4. Starting grill
Because of hot air flow coal will flame up at once.
5. Defrosting
It is possible to defrost water pipes, steps or car door locks.
6. Soft soldering
Before soldering clean the location to be soldered, warm by hot air flow and apply sol -
der. Fluxing material, protecting from corrosion is used for soldering.
7. Welding plastic or joint loosening
All surfaces must be of the same plastic type.
ATTENTION
The power tool is designed for household usage and is not intended for industrial pur -
poses. Using the power tool in industrial purposes will make warranty null and void.