Zenit Powertools CS-1800 PROFI, Инструкция по эксплуатации, Страница: 4 / 10

4
19. Stay alert. Watch what you are doing. Use common sense. Do not operate tool
when you are tired.
20. Check damaged parts. Before further use of the tool, a guard or other part that is
damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment of moving parts, free running of
moving parts, breakage of parts, mounting and any other conditions that may affect
its operation. A guard or other part that is damaged should be properly repaired or
replaced by an authorized service center unless otherwise indicated in this instruction
manual. Have defective switches replaced by an authorized service center. Do not use
the tool if the switch does not turn it on and off.
21. Warning Use only accessories or attachments recommended in this instruction
manual or in the catalogue of ZENIT ТМ.
22. Have your tool repaired by a qualified person. This electric tool is in accordance
with the relevant safety requirements. Repairs should only be carried out by
qualified persons using original ZENIT TM spare parts. Otherwise this may result in
considerable danger to the user.
Safety precautions on using saws
• Keep hands away from cutting area and the blade. Keep your second hand on
auxiliary handle, or motor housing.
• If both hands are holding the saw, they cannot be cut by the blade.
• Do not reach underneath the workpiece.
• The guard cannot protect you from the blade below the workpiece.
• Ajust the cutting depth to the thickness of the workpiece.
• Less than a full tooth of the blade teeth should be visible below the workpiece.
• Never hold piece being cut in your hands or across your leg. Secure the workpiece to
a stable platform.
• It is important to support the work properly to minimize body exposure, blade
binding, or loss of control.
• Hold power tool by insulated gripping surfaces when performing an operation where
the cutting tool may contact hidden wiring or its own cord.
• Contact with a «live» wire will also make exposed metal parts of the power tool
«live» and shock the operator.
• When ripping always use a rip fence or straight edge guide. This improves the
accuracy of cut and reduces the chance of blade binding.
• Always use blades with correct size and shape (diamond versus round) arbour holes.
• Blades that do not match the mounting hardware of the saw will run eccentrically,
causing loss of control.
• Never use damaged or incorrect blade washers or bolt.
• The blade washers and bolt were specially designed for your saw, for optimum
performance and safety of operation.
• Do not use any abrasive wheels.
• Abrasive wheel breakage can cause serious injury.
Additional safety precautions on using saws
Causes and operator prevention of kickback:
• Kickback is a sudden reaction to a pinched, bound or misaligned saw blade, causing