ZENEC ZEM-W703MRM, Инструкция по эксплуатации, Страница: 19 / 32

19
English
13. Do not drop or hit the LCD panel with hard objects, as it may cause permanent damage
to the unit. If you come into contact with any spilled LCD fluid, wash and clean affected
areas with plenty of water and soap and seek medical attention immediately.
14. Refer to authorized dealers or the distributor in your country, if you have any queries
about the product.
Use only the relevant controls to operate the motorized panel.
Do not attempt to force open/close the LCD panel, or make any angle adjust-
ments by hand. Otherwise, permanent damage will occur.
PRODUCT WARRANTY WILL BE VOID IF THIS WARNING IS NOT
FOLLOWED.
REMOTE CONTROL

REMOTE CONTROL FUNCTIONS
1. POWER
■
At first, make sure the engine is running. Then press the
power switch. The LED of the power switch will change to
Green from Red and the LCD monitor open automatically
and turn on.
■
Pressed again, the monitor is switched off and back to the
original position.
2. MODE
■
Select input signal AV 1 or AV 2 with MODE button.
3. MENU +/-
■
The button can be used for selecting menu option (up/down
choice).
4. /-
■
Under “MENU”, it is for decreasing the system value.
■
Normally, it is for adjusting the brightness of screen back-
light.
➁ ➀
➂
➃
➂
ZEM-W703MRM Manual D+E.indd 19 11.07.2005 10:32:37 Uhr