Treatment
CoolSculpting® Elite
System User Manual
30
CS-UM-CM3-02-EN-D
8.
Start Treatment
Note
: If simultaneous treatment is desired, proceed “To perform a simultaneous treatment”
step below.
a. The next screen prompts to start treatment. After confirming that the gelpad and applicator are
positioned correctly, treatment can be started.
b. When ready to start treatment for Applicator A, press
Start
. If using Dual treatment card,
proceed to “To perform a Dual treatment (i.e. to use Applicator B simultaneously during
treatment)” step below.
Example
: Start treatment screen for Applicator A
Note:
With a Dual card, if starting treatment for Applicator A without setting up treatment for
Applicator B, the next prompt asks for confirmation by tapping
Proceed
or to go back to
set up by tapping
Continue Setup
.
Note:
When using the Dual card, there is one start button to start both applicators, after both
applicators are set up.
Note:
If both applicators have the same treatment time, then choose either side A or side B
first. There is a delay timer for start of treatment on the second side for Dual treatment.
This allows time for removal of the first applicator and gelpad for the optional manual 2-
minute massage on the first side before the second side.
Note:
Treatment can be started for both Applicators A and B at the same. Otherwise, only one
Applicator can be used, depending on the need.
►
To perform a Dual treatment (i.e. to use Applicator B simultaneously during treatment):
a. At the touchscreen, tap treatment area on the body.
The highlighted treatment area displays. Tap
Next.
