Treatment
CoolSculpting® Elite
System User Manual
26
CS-UM-CM3-02-EN-D
4. Select Treatment Area
a. On the Select Treatment Area screen, select the appropriate treatment area by tapping
the location on the body.
The desired treatment area highlights bright yellow and remains highlighted.
Note:
For cleared indications for use, contraindications, and warnings, see “Foreword.” For
warnings related to specific treatment sites, see Table 2.
Example:
Treatment area selected for Applicator A
a.
After you select the treatment area, tap Next.
Note:
When performing Dual
CoolSculpting® Elite
treatment, using both Applicators A and B,
ensure that there is at least 2-minute window at the end of the treatment to allow for the
optional massage. This applies if duration of treatment for Applicators A and B are the
same, and both Applicators A and B are used.
b. On the Treatment Profile screen, select a profile from the list; then tap
Next
.
Note
: The profile list displays applicator temperature and treatment duration.
5. Prepare the applicator
Materials required:
•
Gel trap
a. After you tap
Next
, the prompt leads to a new screen for Applicator A to instruct the insertion
of the gel trap on the back side of the applicator (for C120, C150, C240, F125, and F165). For
C80 applicator, the gel trap is in the metal plate in the front of the applicator. The S150
applicator does not have a gel trap.
