ZELTIQ CoolSculpting Elite, Руководство пользователя

Страница: 25 / 74

CoolSculpting® Elite System User Manual Treatment
CS-UM-CM3-02-EN-D 25
Note: If the system displays an error associated with the card (for example, an expired or
incompatible card), find the message code in Table 11 and follow the recommended actions.
c. When the system detects that the card is authenticated, tap OK . The next prompt is “Attach
Applicator A or B.”
Note: The
CoolSculpting® Elite
System consists of Applicator Connector Ports (A and B), which
operate independent of each other. There is an option of attaching either Applicator A or B
or both applicators.
For C120, C150, C240, F125, and F165 applicators: Remove the cap and connect the
applicator to the umbilical. The cap covers the connector of the applicator that connects to the
umbilical.
For C80 and S150 applicators: The C80 and S150 applicators do not detach from the
umbilical.
Plug the umbilical(s) into the connector port(s) on the control unit and rotate the collar
clockwise until the indicator marking(s) line up with the lock symbol.
d. After confirming the Clinician Attestation statement, the Patient Information screen appears.
The prompt changes to “Enter Patient Properties.” Select Gender, Patient new to practice or
otherwise, and number of previous CoolSculpting treatments used on the patient. When this
information is entered, tap Next and the prompt changes to “Select Treatment Area.”
Note: The user has the option of using Applicator A, B, or both. For Dual
CoolSculpting® Elite
treatment, it is recommended to set up one applicator at a time (either Applicator A or B)
until ready to start treatment, before setting up the second applicator. The workflow in this
section focuses on setting up Applicator A (instructs to tap “Next”).
Note: Dual indicates two applicator placements per treatment, equivalent to two cycles. Solo
indicates single applicator placement per treatment, equivalent to one cycle.
3. Allē Loyalty Program
a. On the All ē Loyalty Program screen, place All ē Code under the monitor where the red
light is shown.
Note: The All ē Loyalty number or Patient information can be changed up to the starting
treatment step. If the All ē Loyalty number or Gender of the Patient have been
changed, the Clinician Attestation statement will need to be confirmed again.
b. Hold the All ē Code under the red light until a number appears in the entry field above;
then tap Next . Screen should display “Applicator Authenticating” followed by “Applicator
Ready” and “Select Treatment Area” screens.
Note: If no All ē Loyalty number appears in the entry field, then tap Next to enter the All ē
Loyalty number After typing in the All ē number, tap Next .
Note: If no All ē Loyalty number is available, tap No All ē .