Zeiss VISULAS YAG III, Руководство пользователя

Страница: 49 / 126

Installation
000000-1272-175-GA-GB-060613
43
Installation and transport of the VISULAS YAG III
WARNING - GENERAL HAZARDS
This device may only be installed and operated for the first time by persons
who have been authorized by Carl Zeiss Meditec.
CAUTION - PROPERTY DAMAGE
The VISULAS YAG III may only be transported in the carrying case provided
(optional).
If the VISULAS YAG III is to be used as a mobile system, an optionally
available carrying case will be required.
Before transporting the instrument, the following steps should be taken:
•
Disconnect all cables, protective caps and interlock connectors.

To release the cable, grasp the connector by the sleeve and pull it
directly backwards. Pulling on the sleeve releases the lock
mechanism on the connector.
•
Disconnect the binocular tube from the slit lamp.
•
Unscrew the screws fixing the slit lamp base to the instrument table.
•
Remove the key from the key switch on the control unit.
•
Adjust the slit lamp to the lowest height using the joystick.
•
Unscrew the fixation lamp.
•
Put all components into the cardboard boxes as shown in Fig. 15.
Reassemble the equipment in reverse order. The connections are shown
in Fig. 8.

Cables and the corresponding sockets and ports are color-coded
for easy identification. All connectors and sockets are marked with
a red dot. These dots must be vertically aligned when they are
connected. All sockets are labeled.
CAUTION - PROPERTY DAMAGE
Connect only cables and sockets that are the same color and size. Never use
force.
•
Install the door interlock to the control panel (Fig. 8). If you do not wish
to install an interlock, connect the yellow coding plug provided in place
of the interlock (yellow connector, 2, Fig. 8).