Zeiss Transillumination top 450 mot., Руководство по эксплуатации

Страница: 8 / 18

INTRODUCTION
Carl Zeiss Notes on warranty Transillumination top 450 mot.
8 435500-9000-701 08/2012
On microscopes with motorized focusing drive there is a risk of pinching fingers in the work
area when lowering the body of the microscope.
−
Before switching on check that the joystick on the SYCOP 3 is at the zero position and not
swiveled out, and that the foot pedal is clear.
−
Automatic travel can be interrupted by pressing the STOP button on the focusing drive or
the STOP button on the SYCOP 3, moving the joystick on the SYCOP 3 up and down,
turning the knurled wheel on the HIP or pressing the Memory 1 or 2 keys on the HIP.
−
Do not reach into the possible travel path of the motorized table. There is a risk of pinching
or injury to the fingers when the table is positioned by the control unit.
The separate operating manuals for the Axio Zoom.V16, HXP 200 C and SYCOP 3 (if used)
must be observed and the general safety requirements complied with.
−
Operating Manual Axio Zoom.V16: Order No. 435080-9030-701, English edition
−
Operating Manual SYCOP 3: Order No. 435611-9010-701, English edition
When operating the microscope always use the antiglare shield to avoid eye damage due to
scattered light.
Use the UV/antiglare shield (Fig. 1/
I
). Avoid looking directly into the light beam. This can cause
damage to the eyes and skin.
The transillumination top 450 mot. generates extremely high-energy light in the visible and
invisible range. The related instructions for safety and use must be strictly adhered to.
1.3 Notes on warranty
The manufacturer guarantees that the instrument is free of material or manufacturing defects when
delivered. Possible defects must be notified to us immediately and steps taken to minimize damage. If
notified of such a defect, the manufacturer is obligated to rectify it at his discretion, either by repairing
the instrument or delivering an intact replacement. No guarantee is provided for defects caused by
natural wear (wearing parts in particular) and improper use.
The instrument manufacturer shall not be liable for damage caused by faulty operation, negligence or
any other tampering with the instrument, particularly the removal or replacement of instrument
components, or the use of accessories from other manufacturers. Such actions will render any warranty
claims invalid.
With the exception of the work described in this operating manual, no maintenance or repair work is to
be carried out on these microscopes. Repairs may only be performed by Carl Zeiss service staff or
personnel specifically authorized by Carl Zeiss. In the event of a problem with the instrument, please
contact the Carl Zeiss microscopy service team or your local Carl Zeiss overseas representative.