Zeiss Smartzoom 5, Быстрое руководство

Страница: 14 / 34

3 Referencing Tasks | 3.6 Tilting Pivot Point ZEISS
5. Move the 2 handles to crop the overview image. Adjust the 2 handle positions that they are
within the grey rectangle at the chessboard paper.
6. Click on the Continue button.
à
The image distortion correction was finished successfully.
7. Click on the Continue button.
After the image distortion correction the wizard will continue with the next activated step.
3.6 Tilting Pivot Point
This referencing task will find the best settings for the pivot point. Therefore an alignment sheet is
required. Either the rear side of the new alignment sheet (2294-728) or the front side (chess-
board) of the old alignment sheet (2115-856). As you have to tilt the stand, please read the
Smartzoom 5 instruction manual, where this procedure is described in detail.
1. Ensure that the stand is in upright position. Please notice that for this task the angle-stops
of the stage insert plate must be facing down .
Quick Guide ZEISS Smartzoom 5 | en-US | Rev.1 14