Zeiss S88, Инструкция по эксплуатации

Страница: 96 / 182

96
Operation
G-30-1426-en S88 Floor Stand with Lifting Column Issue 9.0
Printed on 28. 01. 2009
Basic mode
The basic mode is always displayed in the normal operating status and
after power-on of the system.
In the basic mode, the following settings are displayed, depending on the
installed surgical microscope:
Setting the user ID (USER)
The lower display field in the basic mode generally shows the current
USER, i.e. the user ID selected when the system was last switched off is
displayed. When the system is switched on, all settings for this user will
be activated, In combination with
OPMI Vario , the suspension system
loads all settings for a newly selected user when the user is changed.
User data records can be stored for a maximum of 9 different users.
Use buttons "
∇
" and "
Δ
" assigned to the lower display field to select a user
ID between 1 and 9.
Saving parameter settings
As soon as you have entered a parameter setting, it is saved under the
current user ID.
Note:
If possible, each user should be assigned his own user ID under which he
can enter and save his specific parameter settings. This permits each
user to call up his specific set of parameters via his user ID and to work
with these settings.
Caution:
Make sure never to change the settings of another user. It is therefore ad-
visable that you only use your own user ID for your work. Remember that
all settings made are stored under the user ID currently selected.
In the upper display field the current lamp brightness
In the middle display
field for OPMI
®
Vario on the suspension system:
either the working distance or the
total magnification
In the lower display field the user ID
MODE
STORE MANUAL
USER
1
250 mm
1
5.0
Basic mode