Zeiss S100, Инструкция по эксплуатации

Страница: 106 / 278

Preparations for use S100 / OPMI pico
Version 9.0
Page 106 G-30-1781-en
Relocating the S100 floor stand
Please observe the following points when relocating the suspension system:
• Turn off the device at the power switch.
• Remove the power plug from the power outlet.
• Disconnect the video cable between the video modules (e.g. video
monitor, video recorder) and the camera control unit (CCU).
• Adjust the flat screen (optional) to a secure transport position.
• Do not transport the device by pulling or pushing on the flat screen
(option)!
• Avoid any uncontrolled swiveling of the optional flat screen.
• Swing the suspension arm into the transport position.
• Unlock all arrestors of the casters.
• Hold the system by the marked position on the stand column and carefully
push it aside. Make sure that the system is positioned on level ground.
• Press at least two of the arrestors and make sure that the suspension
system is no longer able to move inadvertently.
.Because the stand moves so smoothly, it is easy to underestimate how heavy
it is. Therefore, move the stand slowly and carefully!
CAUTION Risk of crushing and toppling during transportation of the system!
If the following precautions are not observed, the floor stand may topple
over and injure persons!
• Move the floor stand into its transport position.
• To safely move the system, always hold the stand column at the position
marked with a label.
CAUTION Risk of crushing - mind your fingers!
Fingers may be crushed in the areas marked with the "Risk of crushing" label.
• Do not touch these areas while the system is being moved or brought in
its working / transport position.