Zeiss S100/OPMI pico, Инструкция по эксплуатации

Страница: 15 / 278

Version 7.0
G-30-1781-en
Page 15
S100 / OPMI pico Safety Measures
During use
• Reduce the brightness and duration of light exposure of the surgical area
to the absolute minimum level required to avoid burn injuries.
• Never directly look into the light source, e.g. a microscope object lens or
a light guide to avoid phototoxic damages to the eyes.
• Never leave a device unattended with the light source still switched on.
• Not approved or defective accessories for the device may lead to elevated
leakage currents. Never connect the non approved or defective accesso-
ries to the device.
• Never touch video interfaces while in contact with the patient.
• If you need to change the lamp shortly after it has failed, the lamp will still
be very hot. Use heat-resistant protective gloves when replacing the lamp
to prevent burns.
• If the xenon lamp is used beyond its maximum service life of 500 hours
(see chapter "Maintenance intervals" on Page 222), sudden failure may
occur and interrupt operation. Change to the backup lamp or replace the
lamp module in a timely manner.
• If the halogen lamp is used beyond its maximum service life of 50 hours,
sudden failure may occur and interrupt operation. Replace the halogen
lamp in a timely manner (see chapter "Care and Maintenance" on Chang-
ing the halogen lamp on page 1).
• Do not pull at the power cord or any other connecting cables.
• If a failure occurs which you cannot correct with the aid of the chapter
"What to do in the event of malfunctions attach a sign to the system stat-
ing it is out of order and inform ZEISS Service.
• Never operate the system unattended.
• Always switch off the system
- before disconnecting it from / connecting it to line power
- if it will not be used for a prolonged period of time
- or for cleaning purposes.