Zeiss OPMI PROergo S7, Инструкция по эксплуатации

Страница: 88 / 268

Device overview S7 / OPMI PROergo
Version 11.0
Page 88 G-30-1435-en
Support arm and suspension arm
1 Lamp housing with halogen or xenon illumination
The stand is equipped with an illumination system for light guides.
Each lamp housing contains a backup lamp. When a halogen illumination
system is used, the backup lamp will be automatically swung in if the first
lamp fails.
When a xenon illumination system is used, you need to swing the backup
lamp into position manually if the first lamp fails.
2 Friction
Knob for adjusting the friction of the suspension arm's upward/downward
movement.
3 Clamping screw for limiting downward movement
The movement of the suspension arm can be limited in the downward
direction.
Adjustment range: from the horizontal position of the suspension arm to
its lower stop.
4 Balancing
Knob for setting the spring force for balancing. After all the accessories
have been fitted on the surgical microscope, this adjustment screw can be
used to set the balance of the suspension arm. The procedure for setting
the balance is described in the section "Preparations for use".
5 Friction
Knob for adjusting the friction of the suspension arm's swivel movement.
6 Friction
Knob for adjusting the friction of the carrier arm's swivel movement.
7 Control and display panel
The control and display panel permits you to control all electrical functions
of the S7 suspension system and the surgical microscope.
8 Connector panel
Further connectors are provided for powering peripheral equipment.
A foot control panel (option) can be connected to a multi-point
connector.
-
Balance
+