Zeiss OPMI PROergo S7, Инструкция по эксплуатации

Страница: 16 / 268

Safety measures S7 / OPMI PROergo
Version 11.0
Page 16 G-30-1435-en
Before every use
• When mounting accessory equipment, please make sure that the
admissible total weight of the surgical microscope is not exceeded.
(see "maximum load" label or the section "Technical data").
• Before every use, make certain to compensate for any added weight; this
will enable the surgical microscope to maintain its balance in all positions
of the working range.
• Before every use, limit the stroke of the suspension arm to prevent any
contact with the patient if the surgical microscope is lowered accidentally.
• Check the surgical microscope for sufficient freedom of movement. The
device itself or accessories may be damaged if conflicting with each other.
• To make sure that accessories do not fall down, check before each use
that they are firmly seated and the securing screws are firmly tightened.
• When connecting accessories, make sure that there is sufficient clearance
and that the surgical microscope does not touch the patient.
• Before every use, check the user settings in the software to avoid
unexpected behavior of the system.
• Always route cables so that they do not hinder the user.
• Never connect any unknown or defective devices to the electrical
interfaces (e.g. for data, video or foot control panel).
• Connect components only to properly grounded outlets.
• When setting up your system, make sure to comply with the requirements
of IEC 60601-1, chapter 16 (in some countries IEC 60601-1-1 may still be
valid).
• Reattach any covers or caps that have been removed. Close any existing
openings with the corresponding caps.
Before starting the system, remove the protective cover used for
transportation from the objective lens.
• If the xenon lamp is used beyond its maximum service life of 500 hours,
a sudden failure may occur. Change to the backup lamp (see Page 204)
or replace the lamp module in a timely manner (see Page 222). Reset the
service hour counter of the xenon illumination.