Zeiss OPMI PROergo S7, Инструкция по эксплуатации, Страница: 118 / 268

Device overview S7 / OPMI PROergo
Version 11.0
Page 118 G-30-1435-en
Structure of the menus
– If no entry is made for about 30 seconds, the preceding menu will
automatically reappear.
– The data you have entered or changed will not be saved until you press
the OK button or the Enter button, or when the preceding menu appears
after approx. 30 seconds because no further entries have been made.
Start of menu
After you have switched on the system, the software is loaded. The growing
size of the ZEISS logo with the words "Please wait..." below it indicates that
this test is still in progress. The release number is displayed in the top left
corner. The system then performs a self-test.
After successful completion of the test, the "User Selection" menu is
automatically displayed.
User menu
The User menu comprises one standard profile and three other user profiles.
When a user profile is selected, the system imports the settings stored under
this profile, e.g. focusing speed, zoom link setting, zoom speed and handgrip
settings. The stored start values ("Start at") for the magnification factor,
the focus position and the brightness are automatically set. The three user
profiles are used to adjust these settings for different users.
When the system is started up for the first time, the Standard User is
displayed; at every subsequent start-up, the user active last is displayed.
– The Standard User profile allows the adjustment of settings, but these
settings cannot be saved (fixed factory settings).
– In the Standard User profile, all "Start at" fields are deactivated. No bar is
displayed; it is not possible to adjust any settings.
Firmware version 1.1
Please wait ...
USER 1
USER 2
USER 3