Zeiss OPMI Lumera i, Инструкция по эксплуатации

Страница: 14 / 184

Safety measures OPMI Lumera i
Version 8.0
Page 14 G-30-1720-en
Requirements for operation
A ZEISS Service representative or an expert authorized by ZEISS will install the
system. Please make sure that the following requirements continue to be met
for further operation:

The connecting components have been properly connected. The screw
connections have been firmly tightened.

All cables and plugs are in perfect condition.

The voltage set on the system corresponds to the rated line voltage on the
site of installation.

The power cord has been plugged into a power outlet which is properly
grounded.

The device is connected with the power cord supplied.
Before every use
• Make sure that all function tests before use are performed and the
requirements specified above fulfilled.
• Go through the checklist in the chapter “Operation” (see Page 93).
• Comply with all symbols, instructions, and labels on the device.
• Never cover any ventilation openings.
• Press the locking tabs on the stand base to secure the stand in position.
Make sure that the stand is stable and cannot roll away.
• Check that the movement of the surgical microscope is unobstructed to
avoid any collisions and damage to cables.
• Check the user settings in the software to avoid unexpected behavior of
the system.