Zeiss OPMI 1FR XY, Инструкция по эксплуатации

Страница: 56 / 114

56
Preparations for use
G-30-1416-en OPMI® 1FR XY Surgical Microscope on S7 Floor Stand Issue 4.0
Printed on 14. 11. 2007
Attaching the equipment
Mounting the tube, the eyepieces and the objective lens
• Bring the suspension in a position convenient for you and tighten fric-
tion adjustment knob (1).
Note:
•
Give securing screw (4) a few turns to loosen it.
• Remove cover (2) and store it in a safe place.
• Place binocular tube (5) on the microscope body and firmly tighten se-
curing screw (4).
• You can install other units between the binocular tube and the micro-
scope body. Lock these units in position in the same way using the se-
curing screw (4).
• Insert widefield eyepieces (7) as far as they will go in mounts (6) in-
tended for them. The magnetic coupling reliably secures them in posi-
tion.
• Loosen the friction adjustment knob again and adjust the degree of
friction as required.
Note:
If you wish to use documentation equipment, we can supply an eyepiece
with a reticle to aid focusing. The retrofitting of a reticle to an eyepiece
can only be performed in the factory or by our service staff. Always install
the eyepiece with the reticle in the binocular tube on the same side as the
documentation equipment.
• Screw objective lens (3) into the microscope body and tighten it firmly.
Caution:
– Before every use and after re-equipping the instrument, make sure
that binocular tube (5) is securely locked in position. Make sure that
securing screw (4) and objective lens (3) have been firmly tightened!
– Re-adjust the balance of the suspension arm after every change of the
equipment.