![background image](http://html2.mh-extra.com/html/zeiss/i-profiler-plus/i-profiler-plus_user-manual_3341282049.webp)
Maintenance and care
000000-1520-928_GA_EN_021013
47
Maintenance and care
WARNING - GENERAL HAZARDS
Further maintenance procedures above and beyond those specified in this
section (maintenance, safety inspections and repairs) may only be carried
out by persons authorized by Carl Zeiss and solely according to the service
instructions issued by Carl Zeiss.
Fault remedy
The following troubleshooting tables list possible problems encountered in
the operation of the i.Profiler
® plus
together with the appropriate remedies.
Should problems persist, please contact Carl Zeiss Vision.
Problems with the electric system
Fault/Problem
Possible causes
Remedy
The standby control
lamp does not light up
when the power switch
has been switched on
and the standby button
has been pressed.
Power plug is not
connected.
The fuses are defective.
Ensure that the power plug
is connected to the power
supply.
Check the fuses in the
power switch module (see
page 51).
The device switches on,
but no screen display
appears and the device
head does not move.
Cable problem
Contact customer service.
The device will not
power up or the
application will not
start.
Computer problem
Switch the device off, wait
a minute before switching
it on again.
If the problem persists,
contact customer service.
Содержание i.Profiler plus
Страница 1: ...i Profiler plus User manual...