![background image](http://html2.mh-extra.com/html/zeiss/i-profiler-plus/i-profiler-plus_user-manual_3341282047.webp)
Shutting down
000000-1520-928_GA_EN_021013
45
Shutting down
Switching off the device
•
To switch off the i.Profiler
® plus
software, click on the corresponding
buttons in the software interface or use the standby button (
3
, Fig. 6).
•
Switch the device off by the power switch (
6
, Fig. 9) after the blue lamp
next to the standby button goes off.
Turn the device off by the power switch if it is not used during the
night.
Device components still remain under voltage when the device has
been switched off at the power switch. Complete disconnection
from the power supply is only possible by pulling the power cable.
WARNING - GENERAL HAZARDS
If one of the following events should occur, switch the device off
immediately at the power switch, disconnect the power cable, label the
device clearly as being out of service and report the problem to Carl Zeiss
Vision
•
Electric shocks
•
Penetration of spilled substances
•
Faults that cannot by remedied according to the descriptions in this user
manual.
CAUTION - PROPERTY DAMAGE
The light next to the standby button must be turned off before switching off
the power switch, unplugging from the power supply or switching off the
main room switch. Failure to observe these instructions may result in loss of
data.
Содержание i.Profiler plus
Страница 1: ...i Profiler plus User manual...