ZEISS
2 Safety | 2.2 Safety Procedures
§
The microscope is only to be used by operators who have been trained by a ZEISS service rep-
resentative. Basic operator training and safety instructions will be provided within the scope
of the initial start-up by ZEISS. Make sure that everyone who operates the microscope only
performs the tasks for which he/she is trained.
§
Operators of the microscope must not deviate from the instructions provided in this manual.
§
Only perform preventive maintenance tasks described in this manual. All tasks of mainte-
nance, service, and repair not described in this manual have to be performed by an authorized
ZEISS service representative.
§
The microscope is to be used in a laboratory environment for commercial and scientific pur-
poses only.
Using the microscope for any other purpose is not allowed and can be hazardous.
2.2 Safety Procedures
2.2.1 Safe Operation Conditions
If the product safety labels are covered or worn or if any of the safety devices are not in proper
working condition, operation of the microscope can be hazardous.
§
Periodically check the function of safety equipment.
§
Periodically check that all protective cover panels are installed.
§
Always follow the instructions given on the safety labels.
§
Inspect and clean the product safety labels to maintain good legibility.
2.2.2 Requirements for Personnel
Deviating from the instructions given in this manual and on the safety labels can be hazardous or
can lead to property damage.
§
Do not operate the microscope until you have completely read and understood the entire user
documentation delivered with the microscope.
§
Observe all safety labels on the microscope and within this manual.
§
Only operate the microscope according to the operating conditions after correct installation
by a ZEISS service representative.
§
Only ZEISS service representatives, who have specialized knowledge of radiation protection,
are permitted to service the microscope.
Operator Training
Within the scope of initial start-up, the ZEISS service representative will perform a basic operator
training. The basic operator training consists of fundamental operation procedures including
safety instructions. Besides, an introduction to basic maintenance tasks will be given for an ad-
vanced operator, who has to be an electrically skilled person. The training performed must be
documented appropriately.
Special application training is offered on request.
Instruction Manual ZEISS Crossbeam 350 | en-US | Rev. 3 | 349500-8111-000
13
