Zeiss CONTURA, Руководство по эксплуатации

Страница: 106 / 158

Preparation for measuring operation
7-10
61211-1310402 CONTURA
2 Park position, signs of the coordinates: +X, -Y, and -Z
3 Measuring volume
4 Front view
Performing a homing run
A homing run has to be performed after every start-up of the CMM in
order to determine the home position. By determining the home posi-
tion, the end positions of the CMM are determined, too.
Before starting the homing run, make sure that the probe is within the
measuring volume. Otherwise, homing will not be possible.
Safety instructions
CAUTION
Risk of injury due to homing run as a result of an automatic se-
quence.
Crushing and shearing of body parts. Risk to the eyes caused by the
styli.
—
Ensure that nobody is endangered by the travel movements.
NOTE
The home position cannot be approached with laterally projecting styli.
—
Remove the stylus system from the probe if styli project too far.
NOTE
The homing run is performed automatically. The probe first moves in
the Z axis until it reaches the mechanical end position and then in the X
and Y axes.
Make sure that the homing run can be carried out without any colli-
sions.
—
Move the probe to a position from where the homing run can be
performed automatically.
NOTE
When the RDS articulating system has been swiveled to the side, the
stylus system may collide with CMM parts during the homing run. Addi-
tionally, collision in the measuring range, for example with the work-
piece, may also occur.
—
To avoid collisions, move the RDS to the 0°/0° position.