Zeiss CenterMax, Руководство по эксплуатации

Страница: 116 / 166

7-16
Measuring operation
61211-1020202 CenterMax Operating Instructions
Carrying out a reference point travel
Danger!
The reference point travel is carried out automatically. Before starting
the reference point travel, make sure that nobody is at risk.
• Ensure that nobody is endangered by the travel motions.
Important!
The reference point travel is carried out automatically. The probe head
first moves in the z direction until it reaches the mechanical end posi-
tion and then in the x and y direction.
Make sure that the reference point travel can be carried out without
any collision with components on the measuring table.
• Move the probe head to a position from where the reference point
travel can be carried out automatically.
Start by the measuring
software
The reference point travel is started by the measuring software.
• Read the corresponding chapter in the
➤
operating instructions
for the measuring software.
Safety position after
reference point travel
After the reference point travel, the probe head moves to the safety
position (only with UMESS). The coordinates of this position are
defined in the measuring software. The coordinates must be within
the measuring volume.
Example for safety position: x
=
30, y
=
-30, z
=
-30.
The position of the calibration standard has to be determined after
every reference point travel. Furthermore, all probes have to be cali-
brated and the storage positions in a probe rack have to be deter-
mined again.
Probe calibration
The measuring software is required for the following procedure.
• Please read the corresponding chapters in the operating instruc-
tions for the measuring software.
!
!
NOTE
NOTE