![background image](http://html1.mh-extra.com/html/zeiss/axio-vert-a1/axio-vert-a1_operating-manual_927645073.webp)
OPERATION
Axio Vert.A1
Use of Objectives
Carl Zeiss
05/2012
431030-7044-001
73
4.5
Use of Objectives
Objectives for Bright Field and PlasDIC
−
EC Plan-Neofluar 1.25x
−
EC Plan-Neofluar 2.5x
−
A-Plan 2.5x
−
A-Plan 5x
−
LD A-Plan 10x to 63x (also suitable for phase contrast if available as Ph objective)
−
LD Plan-Neofluar Korr 20x, 40x, 63x (also suitable for phase contrast if available as Ph objective)
When Ph objectives are utilized for PlasDIC, imaging quality is slightly diminished.
Objectives for the VAREL, Phase Contrast, DIC or iHMC Contrast Techniques
In order for the objectives to be used for these contrast techniques, the objectives must be expressly
approved for them. (See identifier on the objective.)
4.6
ECO Power-Saving Function
The
ECO
function should be used for short-time microscope use. This will save energy and extend the
service life of the transmitted light illumination (halogen lamp).
Activating the Power-Saving Function
•
Put the
permanent
/
ECO
15
) switch into the
ECO
position.
The illumination will automatically shut off after approximately 15 minutes of operation and go into the
stand-by mode.
•
You can terminate the power-saving function by pressing the
On/off
control button (Fig. 2-8/
13
), so
that the illumination gets switched on again.
•
If the
On/off
control button is actuated during the operation of the microscope, the power-saving
function will be activated immediately, with the illumination turned off. Pressing the
On/off
button
once more will switch the illumination on again.
Deactivating the Power-Saving Function (Normal Operating Mode)
•
Put the
permanent
/
ECO
switch into the
permanent
position.
The illumination will stay switched on permanently. You can turn the illumination on and off by pressing
the
On/off
control button.
Содержание Axio Vert.A1
Страница 1: ...Operating Manual Axio Vert A1 Inverted Microscope ...
Страница 106: ......