Zeiss 000000-1080-349, Инструкция по эксплуатации

Страница: 74 / 278

System Overview S100 / OPMI pico
Version 7.0
Page 74 G-30-1781-en
Connector panel of the xenon light source
1 Light guide socket
The light guide socket is used to direct the light from the light source to
the surgical microscope.
2 Strain relief device
The strain relief device prevents inadvertent unplugging of the power
cable.
3 Power switch
When the device is switched on, the green indicator light in the power
switch is lit.
4 Power supply socket
The power cord connects the device to the power socket. Only connect
the system to a wall outlet which is properly grounded.
5 Selector switch for rated voltage and voltage switchover
The rated voltage indicated at the sliding switch must correspond to the
rated voltage of the net available on the site of installation. If the rated
voltage has not been correctly set, you can adjust the sliding switch using
a suitable tool.
6 Potential equalization connector (can be ordered separately, optional)
This connector can be used for placing other active devices at the same
ground potential or for redundant grounding to protective earth.
Fig. 38: Connector panel for
the xenon light source
3
4
5
1
2
6