Zebex Z-6910, Руководство по программированию

Страница: 5 / 315

Omnidirectional Laser Scanner v
P
ROGRAMMING
G
UIDE
Laser Safety
The laser scanner complies with safety standard IEC 60825-1 for a Class I laser produce.
It also complies with CDRH as applicable to a Class IIa laser product. Avoid long term
staring into direct laser light.
Radiant Energy
The laser scanner uses one low-power visible laser diodes operating at 650nm in an opto-
mechanical scanner resulting in less than 3.9
μ W radiated power as observed through a
7mm aperture and averaged over 10 seconds.
Do not attempt to remove the protective housing of the scanner, as un-scanned laser
light with a peak output up to 0.8mW would be accessible inside.
Laser Light Viewing
The scan window is the only aperture through which laser light may be observed from
this product. A failure of the scanner motor, while the laser diode continues to emit a
laser beam, may cause emission levels to exceed those for safe operation. The scanner
has safeguards to prevent this occurrence. If, however, a stationary laser beam is
emitted, the failing scanner should be disconnected from its power source immediately.
Adjustments
Do not attempt any adjustments or alteration of this product. Do not remove the
protective housing of the scanner. There are no user-serviceable parts inside.
Caution
Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous laser light exposure.
Optical
The use of optical instruments with this product will increase the eye hazard. Optical
instruments include binoculars, magnifying glasses, and microscopes but do not include
normal eye glasses worn by the user.