Zebex Z-3060, Руководство пользователя, Страница: 13 / 19

Handheld Omnidirectional Laser Scanner
7
U
SER
’
S
M
ANUAL
Setting up the Scanner
In certain cases no setup is required. The scanner is either pre-programmed to suit the
situation, or it automatically detects and is ready to go. In other cases the scanner must
be informed about what kind of system it is connected to. This can be done using the
Programming Guide.
The Programming Guide may be used to set a number of parameters on the scanner:
communication interface type (RS-232, Keyboard, USB), beep tone, sleep mode timings,
same-code delay time, enable/disable decoding of numerous code types, and more
advanced things like set headers and trailers.
Individual parameters may be set at any time without affecting the other parameters.
Scan Test
1. With the scanner running (LED blue) and the host system on, try to scan several
known-good barcodes.
2. Check the results on the POS screen. If the scanner is reading okay, no further
setup may be necessary.
3. If the POS screen does not show the expected scans, go to Set Up, below.
Set Up
1. With the scanner running (LED blue) and the host system on, present the <Start of
configuration> barcode, found in the Programming Guide, to the scanner.
2. The scanner gives two beeps: low and high, and the LED turn red. The scanner is
in programming mode.
3. Decide which parameters are required and find their barcodes in the programming
section.
4. Cover unwanted codes with your hand and present the desired codes, one by one,
to the scanner, the scanner beeps once as it accepts each code.
5. When done, again present the <End of configuration> barcode. The scanner
beeps twice, once long and once short, and the LED returns to blue. The scanner
has been programmed.
6. Test again with known-good barcodes. If results are good, you are done setting up.
Otherwise, return to step 1 and try again.