10
User manual
EN
PoSiTioninG The roBoT in The charGinG BaSe
Gently immerse the machine in the water.
Attach the retrieving hook on the pole to clean the pool (not
included).
Using the retrieving hook supplied, bring the recharging side
(identified by a sticker affixed to the body of the robot) in contact
with the plate of the charging base.
danger - attention
The first charging of the robot does not have to be
performed out of the water. It can be brought close
to the charger for ten minutes or so.. This operation
allows waking the robot from stand-by mode and
programming it.
Once the machine has been placed on the charging base, check that the leds are on and steady. If the green or blue LED is off or
flashing, consult the TROUBLESHOOTING section.
On first use, leave the robot to recharge for at least 15 minutes, then retrieve the robot using the hook supplied and remove it from
the water. Program the settings using the remote console.
If the robot has already been programmed, it will start its work cycle within the scheduled time once the batteries are charged.
USo e fUnzionamenTo
Содержание Marlin
Страница 1: ......
