802.11ax Access Point
User Manual
58-150006-IQN_V1.0
Page 4
C
HAPTER
3. H
ARDWARE
I
NSTALLATION
3.1. Mounting the Access Point on the Pole
Place the mounting bracket to the device using four
screws (included in the packaging). Securely tighten
the screws.
Attach the clamp to encircle pole and the
mounting bracket. Securely tighten the
clamp.
3.2. Grounding Connection & Protect from Lightning
1.
Make your device GND port connect to ground wire.
2. The ground wire connects to the earth. In addition, the grounding wire meets to 6-AWG copper grounding wire.
Note:
In order to prevent the radio inflection, it is recommended to
power the device after rotate the antenna.
Note:
Be sure that grounding is available and that it must comply with
local and national electrical codes. For additional lightning
protection, use lightning rods and lightning arrestors.
3.3. Safety Notice
1.
Do not install the device close to any electrical grounding device or lightning protection system. Place the device’s
own grounding and lightning protection system apart from any electrical grounding device and lightning
protection system as far as possible.
2.
Protect components from electrostatic discharge: Please wear an ESD wrist strap or handle the power adapter by
its edge and do not touch any component or printed circuit boards, especially for module device.
3.
Make sure to keep the temperature and humidity of the installation location at an optimal level.
4.
An excellent grounding system guarantees the stable operation of device, as well as to protect device from
lightning, interference and electrostatic discharges.
5.
Supply stable power to the device. Unstable power may cause the device to malfunction. The device supports PoE
power supply and is recommended if the device is installed near grid lines within less than 100 meters radius.
Содержание SP250
Страница 1: ...ZCOM SP250 SP250 S5 11ax Access Point...