Zcom SP250, Инструкция по эксплуатации, Страница: 15 / 62

802.11ax Access Point User Manual
58-150006-IQN_V1.0
Page 12
4.3. Fat AP Mode
A Fat AP is suitable for family and small-scaled networks and provides full features. This Fat AP is wireless equipment
used to control and manage wireless clients. The Fat AP may support both 2.4GHz and 5GHz band in a single logic
management domain. This Fat AP is used for wireless terminals to access a wired network; also it can communicate the
bridge between the wireless clients and wired network. Before configuring the Fat AP make sure that AP is in Fat AP
mode. If the AP is in Thin AP mode, please change into Fat AP mode and precede the following essential
configuration.
4.3.1. Status
4.3.1.1. Overview
This page is used to provide an overview of the software settings and status of the AP. The following parameters are
available in the System section:
Parameter Description
Hostname
Displays the hostnames of active DHCP clients connected to the AP. DHCP stands for
Dynamic Host Configuration Protocol.
Model Displays the AP Model.
Firmware Version Displays the AP firmware version.
Kernel Version Displays the Linux kernel version.
Local Time Displays the local time in your area.
Uptime Displays the how long the AP is active.
Load Average
Displays the average system load calculated over a given period of time of 1, 5 and 15
minutes.
The following parameters are available in the Memory section:
Parameter Description
Total Available Displays the total memory supported by the AP in kilobytes and percentage.
Free Displays the free memory on the AP in kilobytes and percentage.