802.11ax Access Point
User Manual
58-150006-IQN_V1.0
Page 7
4.2. Thin AP Mode
The procedure for completing the access p
oint’s essential configuration depends on whether you want it to be
managed by wireless LAN controllers (WLC).
To configure the access point to be managed by the WLC, you must ensure that the APs will be able to locate and
connect to the WLC when powered on. When connected to the network, each AP is assigned a valid IP address.
4.2.1 Access Point Configuration
In a default access point configuration, the access point default AP mode is TAP mode, and
obtains IP addresses from
DHCP Option 43 protocol
.
Note:
In TAP mode, the AP must be able to go with Wireless LAN Controllers (WLCs) for bulk configuration and
performing other commands of access points. Please refer to WLC QSG for settings first, then go back to finish
the AP configuration.
https://www.zcom.com.tw/index/downloads?keyword=&meterial_type=49
Step 1.
Power on the access point. As the status of LED indicator from flashing change to steady red, the
connection is successful.
Note:
Please make sure DHCP server is enabled on the network once accomplished WLC settings. The
access point must receive its IP address through DHCP server.
Note:
Switching from DHCP to assign a static IP address or DNS and L2 discovery mode to the access point,
please refer to the user manual for more information.
https://www.zcom.com.tw/index/downloads?keyword=&meterial_type=25
If the access point cannot connect to the WLC by DHCP broadcast, please refer to the following optional settings.
Optional: Set up a static IP address
Note:
The following procedure assumes that Windows 10 is the operating system. Procedures for other
operating systems are similar.
Step 1.
On your computer, configure your network adapter from the “Local Area Connection “settings as follows:
˙
Start
→
Control Panel
→
Network & Internet
→
Change Adapter Options
→
Ethernet
Step 2.
Edit the TCP/IPv4 address setting as follows:
˙
Properties
→
Internet Protocol Version 4 (TCP/IPv4)
Step 3.
Select
“
Use the following IP address
”
and make the following entries:
˙
IP address: 192.168.1.168 (or any available address in the 192.168.1.x network, except 192.168.1.1)
˙
Subnet mask: 255.255.255.0
Leave the “Default gateway” and “DNS server” fields empty.
Step 4.
Click “OK” to save your changes.
Login into the access point
Step 5.
Launch a Web browser; type default URL https://192.168.1.1 to connect to the access point. When a
security alert dialog box appears, click OK/Yes to proceed.
Step 6.
When login page appears, enter the following: Username:
root
/Password:
password
Step 7.
Click login.
Customizing the Wireless Settings
On the Web interface menu, Select Status
→
General in the menu bar. Check your switchmod item to select
“
Connect
with via IP
”
, and setup your WLC IP address on
“
Wireless Switch Address 1
”
.
Содержание SP250
Страница 1: ...ZCOM SP250 SP250 S5 11ax Access Point...