Zaxcom Miniature Digital Recorder User’s Manual____________________________________Chapter 5
45
Parameters:
(value range:
0
to
99
, step:
1
)
To use the remote control function, a group code must be selected. If it has not been selected, the IFB100
remote control is not enabled.
When setting the group code, be sure it is unique. This is very important when multiple wireless groups are in the
same area, since any IFB100 on the same group code as yours can affect your TRX9xx/ZFR100 units. To avoid
this, coordinate with others in the area and ensure everybody is on a separate group code.
Once the group code is set, multiple TRX9xx/ZFR100 units can be controlled remotely.
Remote Control Unit ID page
REMOTE CONTROL
UNIT ID=001
Page purpose:
This page maintains the number used to uniquely identify this transmitter.
Parameters:
(value range:
1
to
200
, step:
1
)
ALL
When using the IFB100, this identifier is used to remotely control one specific unit out of the entire group. This
information is also useful in Post to identify the unit since it is recorded in the BWF metadata.
IFB Transmitter Power page
IFB TX POWER: 7
Page purpose:
This page sets the IFB transmitter power output.
Parameters:
(value range:
7
to
0
, step:
1
)
{
7
is full power.}
Use the lowest power setting for a given situation to conserve battery power.
TV Channel Minimum page
MIN FREQ: 560.0
(TVCHAN MIN 29)
Page purpose:
This page maintains the frequency scan‟s starting channel.
Parameters:
(value range:
16
to
99
, step:
1
)
It should be the same as the start of the unit‟s block. The exception is when you know you will only be able to use
the frequencies associated with only one or two channels. This will prevent you from assigning an out-of-bound
frequency.
TV Channel Maximum page
MAX FREQ: 590.0
(TVCHAN MAX 33)
Page purpose:
This page maintains the frequency scan‟s ending channel.
Parameters:
(value range:
16
to
99
, step:
1
)
It should be the same as the end of the unit‟s block. The exception is when you know you will only be able to use
the frequencies associated with only one or two channels. This will prevent you from assigning an out-of-bound
frequency.
