Zaxcom URX100, Руководство пользователя, Страница: 15 / 26

Zaxcom URX100 Set Up Menu
15
SETUP MENU
Tone Output
The tone menu allows the URX100 to output tone. This is useful to set levels and check routing. Pressing
the CH UP and CH DOWN keys key will cycle through and output the different tone settings.
•
OFF - No tone is being outputted.
•
-20dBFS
-Tone is outputted at -20dBFS.
•
+0dBFS
- Tone is outputted at full scale 0dBFS.
Modulation Select
The modulation menu is where the receive format is set. Modulation is simply the way a transmitter
“modulates”, or sends, its signal to the URX100. This setting needs to match the modulation mode that the
corresponding transmitter is set to - if the two setting do not match the URX100 will not be able to receive and
decode the signal from the transmitter.
Modulation types
•
STEREO - Select when receiving audio from a Camera Link, Maxx transmitter, or a stereo transmitter.
•
ZHD 96 - Select when receiving signal from a ZHD transmitter set to ZHD-96.
•
XR MONO - Select when using extended range modulation (XR).
•
MONO - Select when using a mono transmitter and XR modulation is not available in the software.
•
EU
- Select when using a transmitter that is set up for European broadcast standards.
Mute If Unit Code
This menu sets if transmitters with certain ZaxNet unit codes will not be able to be monitored by the URX100.
For example if this menu is set to 30 any transmitter with a ZaxNet unit code below 30 will not be able to be
monitored by the URX100.
If a muted preset is selected to be monitored “MUTE” will appear on the display and that preset will not be able
to be listened to - even if that preset is enabled.
MUTE IF UNIT CODE
(NEVER MUTE)
TONE :
OFF
RX FORMAT:
STEREO
MUTE IF UNIT CODE
IS LESS THAN 2