Zaxcom URX100, Руководство пользователя, Страница: 11 / 26

Zaxcom URX100 Scan Menu
11
SCAN MENU
Frequency Scan
The frequency scan menu is where the URX100 can scan the user specified frequency range and search for a
clear frequencies. The frequency range will be displayed on the bottom half of the display.
After the scan is completed a graphic display of the RF that is present in that specified range will be shown and
the URX100 will also suggest a clear frequency. That frequency can be accepted by pressing the CH UP key. Or
press the CH DOWN key to skip the first chosen frequency and have the URX100 suggest another frequency.
Scanning for a frequency
•
Turn off the transmitter(s).
•
From the scan menu press the CH UP key to initiate a scan.
•
While the URX100 is scanning, the frequency being examined is
displayed in the bottom half of the screen. Once the scan has
completed a graphic map of the scan will be displayed. The low end of the frequency range is on
the left side and the high end is on the right. Wherever RF is found, a vertical line will be drawn.
The line extends from the baseline up. The length of the line indicates the level or strength of the
found RF at that frequency.
Selecting the frequency
When the scan is complete the URX100 will draw a vertical blinking
line on the display to indicate where the first suggested frequency is,
and the frequency in MHz will appear below the scan graphic.
•
Press the CH UP key to accept the new frequency.
•
Press the CH DOWN key to decline and suggest a different frequency.
PRESS TO SCAN
(ALL 200: 512 – 698)
SCANNING 568.9
TO TAKE 618.2