Zato CAYMAN FCE II Series, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 65 / 96

65 / 96
CAYMAN
Version 01 - Revision 00
09/05/2017
Checking the clearance between the main upper jaw blades and the main jaw blades
Checking the clearance between the main upper jaw blades and the main jaw blades requires:
- a thickness gauge�
For the following description, refer to fig. 23 on page 65 �
To check clearance between the main upper jaw blades and the main jaw blades, perform the operations
below in the following order:
1� open/close the upper jaw to reach the position indicated in fig. 23 on page 65 ;
2� measure the distance between the main upper jaw blades (1) and the main jaw blades (2) , using a
thickness gauge as indicated in fig. 23 on page 65 ;
3� if the distance exceeds 0�5 mm in at least one point:
3�1� adjust the main jaw blades by referring to “7.2.3.4 adjusting the main blades on the jaw” on
page 76 ;
3�2� repeat the measurement in point 2;
3�3� if the distance still exceeds 0�5 mm in at least one point, replace the blades by referring to
“7.2.3.3 replacing the main blades” on page 74 ;
2
1
fig. 23 Checking the clearance between the main upper jaw blades and the main jaw blades