Zanussi ZWD 14791 W, Руководство пользователя, Страница: 10 / 36

Changing a running programme is possible only by reset-
ting it. Turn the programme selector dial to and then
to the new programme position. Start the new programme
by pressing the button 8 again. The washing water in the
tub will be not emptied out.
Interrupting a programme
Press the button 8 to interrupt a programme which is run-
ning, the corresponding green pilot light starts blinking.
Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to to cancel a programme which
is running.
You can select now a new programme.
Opening the door
After the programme has started (or during the delay time)
the door is locked, if you need to open it, set first the ma-
chine to PAUSE by pressing the button 8.
If the door cannot be opened, this means that the machine
is already heating or that the water level is too high. Do
not try to force the door!
During drying phase the door can be opened only the first
10 minutes and at the end of drying (after Anti-Crease
phase).
If you cannot open the door but you need to open it you
have to switch the machine off by turning the selector dial
to O. After a few minutes the door can be opened (pay at-
tention to the water level and temperature!).
After closing the door, it is necessary to select the pro-
gramme and options again and to press button 8.
At the end of the programme
The machine stops automatically. Three blinking 0.00 ap-
pear on the display and the pilot light of button 8 goes off.
Some acoustic signals sound for a few minutes.
If a programme or an option that ends with water left in the
tub has been selected, the door remains locked to indicate
that the water must be emptied out before opening the
door.
Follow the below instructions to empty out the water:
1. Turn the programme selector dial to O.
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by pressing the
relevant button.
4. Press button 8.
At the end of the programme, turn the programme selector
dial to O to switch the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
Stand by : once the programme has finished after a few
minutes the energy saving system will be enabled. The
brightness of the display is reduced. By pressing any but-
ton the appliance will come out of the energy saving sta-
tus.
Use - Drying
Drying only
Warning!
The recommended load size is 4 kg for cottons and linen,
and 3 kg for synthetic items.
By pressing Drying Time button it is also possible
to dry up to 6 kg of cotton items (see the «Drying
Programme » table).
Warning!
The water tap must be open and the drain hose must be
positioned in the sink or connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum spin speed al-
lowed for the type of laundry in order to obtain the
best drying performances.
3. Select the drying programme for Cottons or Synthet-
ic in the Drying sector of the programme selector di-
al.
4. If you wish to select an electronic drying, depress
the button 4 until the icon corresponding to the re-
quired dryness degree appears on the display,
marked with the icon .
5. If you wish to select a timed drying, press button 5
until the time you want appears on the display (see
the «Drying Programme» table). Every time you
10