If the function: Descaling is not
performed in the correct way, the
display will show a message to repeat
it.
If the oven is humid or wet, wipe it out with a dry
cloth. Let the oven dry fully with the door open.
DESCALING REMINDER
There are two descaling reminders which remind
you to perform the function: Descaling. These
reminders activate each time you switch off the
appliance.
The soft reminder reminds and recommends you to
perform the descaling cycle.
The hard reminder obligates you to perform the
descaling.
If you do not descale the appliance
when the hard reminder is on, you
cannot use the steam functions.
You cannot disable the descaling
reminder.
STEAM GENERATION SYSTEM - RINSING
Remove all accessories.
Select the function from the menu: Cleaning. The
user interface will guide you through the procedure.
The duration of the function is around 30 minutes.
The light in this function is off.
1. Put the baking tray on the first shelf position.
2. Press
.
3. Fill the water drawer with fresh water to the
maximum level until the acoustic signal sounds
or the display shows the message.
4. Press
.
Remove the baking tray after the end of the
procedure.
TANK EMPTYING
Remove all accessories.
The cleaning function removes the residual water
from the water drawer. Use the function after the
steam cooking function.
Select the function from the menu: Cleaning. The
user interface will guide you through the procedure.
The duration of the function is around 6 minutes.
The light in this function is off.
1. Put the baking tray on the first shelf position.
2. Press
.
Remove the baking tray after the end of the
procedure.
REMOVING AND INSTALLING THE DOOR
You can remove the door and the internal glass
panels to clean it. The number of glass panels is
different for different models.
WARNING! The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on the two
door hinges.
A
A
3. Close the oven door to the first opening
position (approximately 70° angle).
4. Hold the door with one hand on each side and
pull it away from the oven at an upwards angle.
5. Put the door with the outer side down on a soft
cloth on a stable surface.
6. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
1
2
B
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top edge
one by one and pull them up out of the guide.
9. Clean the glass panel with water and soap. Dry
the glass panel carefully.
When the cleaning is completed, do the above
steps in the opposite sequence. Install the smaller
panel first, then the larger and the door.
43