Zanussi ZOF35501, Руководство пользователя

Страница: 14 / 24

Stainless steel or aluminium applian-
ces:
Clean the oven door with a wet sponge only.
Dry it with a soft cloth.
Do not use steel wool, acids or abrasive materi-
als as they can damage the oven surface.
Clean the oven control panel with the same
precautions
Catalytic walls
The walls with a catalytic coating are self-
cleaning. They absorb fat which collects on
walls while the oven operates.
To support this self-cleaning process heat
the oven without any food regularly:
1. Open the oven door.
2. Remove all accessories from the oven.
3. Close the door.
4. Set the maximum oven temperature and let
the oven operate for 1 hour.
5. Clean the oven cavity with a soft and damp
sponge.
Caution! Do not attempt to clean catalytic
surfaces with oven sprays, abrasive
cleaners, soap or other cleaning agents. This
may damage the catalytic surface.
Discolouration of the catalytic surface has
no effect on catalytic properties.
Shelf Support Rails
You can remove the shelf support rails to clean
the side walls.
Removing the shelf support rails
1
Pull the front of
the shelf support rail
away from the side
wall.
2
Pull the rear shelf
support rail away
from the side wall and
remove it.
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
The rounded ends of the shelf support
rails must point to the front.
Oven door and glass panels
To clean the oven door remove it.
Caution! Be careful when you remove the
door from the appliance. The door is
heavy!
Removing the oven door
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two door
hinges fully.
A
A
3. Close the oven door until the first position
(angle approx. 45°).
14
www.zanussi.com