Zanussi ZKH 2145, Руководство пользователя, Страница: 16 / 36

16
pour it into the main wash compartment
and, if you wish to carry out a programme with
the prewash phase, pour it into the
compartment marked .
If required, pour fabric softener into the
compartment marked (the amount used
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
Select the required programme by means of
the programme selector dial (1)
Turn the programme selector dial to the
required programme. The green light of button
8
starts to flash.
It can be turned either clockwise or
anticlockwise. On position «O» the programme
is reset and the machine is switched OFF.
At the end of the programme the selector
dial must be turned to position « O » , to
switch the machine off.
IMPORTANT!
If you turn the programme selector dial to
another programme when the machine is
working, the red light will of the button
8
flashes 3 times and the message Err is
displayed on the display to indicate a wrong
selection. The machine will not perform the
new selected programme.
Select the spin speed or the Rinse Hold
option by pressing button
2
The relevant light will light up.
When selecting a programme, the light
corresponding to the maximum speed allowed
for that programme will illuminate.
Select the degree of dryness or the duration
of the drying cycle by means of buttons
3
and
4
The relevant light illuminates.
By depressing the button
3
it is possible to
select the degrees of dryness for cotton or
synthetics items. The washer dryer will
automatically adjust the duration of the drying
cycle to the selected degree.
Also this button allows you to select a drying
time for Cottons and Synthetics from 10
minutes to 130 minutes (
2.10
). Every time you
press this button the time increases by 5 mins.
Select the desired option by means of
buttons
5
and
6
Depending on the programme, different
functions can be combined. These must be
selected after choosing the desired programme
and before depressing the button
8.
The
corrisponding light illuminates.
For more information about the compatibility of
the options with the washing programmes,
refer to the section «Programme table».
Select the delayed start by pressing the
button
10
Depress this button to select the required
delay.
The selected delay time value will appear on
the display for few seconds, then the duration
of the programme will appear again.
You must select this option after you have set
the programme and before you press the
button
8
.
You can cancel the delay time at any moment,
before you press button
8
.
If you have already pressed it , and you wish
to cancel the delay time, proceed as follows:
• set the washing machine to PAUSE by
pressing button
8
;
• press the button
10
once. On the display will
appear the symbol «
0’
».
• press button
8
again to start the programme.
IMPORTANT!
• If the programme has already started, the
selected delay can be modified only after you
have turned the programme selector dial to
132964550.qxd 05/03/2008 15.45 Pagina 16