Zanussi ZBB27450SA, Руководство пользователя

Страница: 13 / 16

Installing the appliance
Make sure that the mains cable can
move freely.
1. If necessary cut the adhesive sealing strip
and then apply it to the appliance as shown
in figure.
x
x
2. Push the appliance in the direction of the
arrows (1) until the upper gap cover stops
against the kitchen furniture.
3. Push the appliance in the direction of the
arrows (2) against the cupboard on the
opposite side of the hinge.
1
2
4. Make sure that the distance between the
appliance and the cupboard front-edge is
44 mm.
4mm
44mm
The lower hinge cover (in the accessories
bag) makes sure that the distance between
the appliance and the kitchen furniture is
correct.
5. Make sure that the clearance between the
appliance and the cupboard is 4 mm.
6. Open the door. Put the lower hinge cover in
position.
7. Attach the appliance to the niche with 4
screws.
I
I
8. Remove the correct part from the hinge
cover (E). Make sure to remove the part DX,
in the case of right hinge, SX in opposite
case.
9. Attach the covers (C, D) to the lugs and the
hinge holes.
E
E
D
C
B
10. Install the vent grille (B).
11. Attach the hinge covers (E) to the hinge.
12. Connect the appliance laterally to the
kitchen furniture sidewall:
a. Loosen the screws of the part (G) and
move the part (G) till the furniture
sidewall.
b. Tighten the screws of the part (G)
again.
c. Attach the part (H) to the part (G).
G H
13. Disconnect the parts (Ha), (Hb), (Hc) and
(Hd).
www.zanussi.com 13