ZANOLLI SYNTHESIS 12/80V E, Руководство по установке, использованию и обслуживанию

Страница: 12 / 60

4. INSTALLATION
12 SYNTHESIS E
The figure below shows the position of the equipotential bonding terminal
on the oven and its symbol:
The coupling between plug and socket must be such that the earth
conductor is connected first and disconnected last and must have the right
dimensions for the rated current (see Enclosure A). Plugs and sockets for
industrial use of the type CEE17 are suitable or those which satisfy
European norm EN 60309.
The electrical socket must be easily accessible and must not require
further location after the installation of the equipment. The distance
between the equipment and the socket must be sufficient to avoid
stretching the power cable.
For the position of the electrical power connections see Enclosure B.
The power cable must never be trapped under the feet or
wheels of the equipment.
If the power cable is damaged it must be substituted by
customer support or by a qualified service engineer so as to avoid
any risk.
The Manufacturer does not accept responsibility for damage
caused by failure to observe the abovementioned norms.
4.7. Exhaust produced by combustion
ATTENTION! Carry out the installation of the oven according to
the standard defined by the norms in force for this type of equipment
in the country in which it is being installed. For more information refer
to these norms.