MAINTENANCE
32
Synthesis
06/40V GAS
8.3 REPLACE BATTERY
The alarm message “BATTERY” has to be referred to the buffer battery of the electronic
base board, which is over and must be replaced.
The message on the display is given together with an alarm, which intermittently sounds.
Switch off the alarm sound by pressing the key
.
For replacing the battery it is necessary to remove the fixed guards on the electric panel.
Before carrying out any maintenance operations check that the main cable plug is
disconnected from the power.
The battery is located in the middle of
the electronic base board, see fig. 8.1;
for replacing the battery, please follow
carefully the steps listed below:
-
switch
off
the
oven
and
disconnect it from the main
power;
-
remove
the
guards
of
the
electronic panel;
-
replace the old battery with a new
one;
-
connect the oven to the power
and switch it on;
-
set
the
current
time
(see
paragraph 5.4.1);
-
switch off the oven again and
disconnect it from the main
power;
-
connect the oven to the power
and switch it on again.
Now everything is ok, your battery
won't give any other alarm; and you can
start working.
In case the “BATTERY” alarm still
remains after replacing the battery, please don’t forget to set the clock of the base board (see
paragraph 5.4.1). Then disconnect the oven from the main power and connect it again.
This operation permits to reset the base board and delete any other alarms in memory.
Fig. 8.1 Electronic panel, position of the BATTERY.
BATTERY
Содержание SYNTHESIS 06/40V GAS
Страница 35: ...MAINTENANCE 35 Synthesis 06 40V GAS Fig 10 1 Wiring diagram for synthesis 06 40V gas 230 Vac 1 N 50 60Hz...
Страница 38: ...MAINTENANCE 38 Synthesis 06 40V GAS FIG 10 2 Exploded view Synthesis 06 40V gas components of carpentry...
Страница 39: ...MAINTENANCE 39 Synthesis 06 40V GAS FIG 10 3 Exploded view Conveyor Synthesis 06 40V gas...
Страница 44: ...DECLARATION OF CONFORMITY 44 Synthesis 06 40V GAS 10 DECLARATION OF CONFORMITY...
