Problem
Possible cause
Remedy
The heat setting changes be‐
tween two levels.
Power management operates.
Refer to "Daily use".
The control panel becomes
hot to the touch.
The cookware is too large or you
put it too close to the control pan‐
el.
Put large cookware on the rear
zones, if possible.
There is no sound when you
touch the panel sensor fields.
The sounds are deactivated.
Activate the sounds. Refer to "Daily
use".
comes on.
Child Safety Device or Lock oper‐
ates.
Refer to "Daily use".
comes on.
There is no cookware on the
zone.
Put cookware on the zone.
The cookware is unsuitable.
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
The diameter of the bottom of the
cookware is too small for the
zone.
Use cookware with correct dimen‐
sions. Refer to "Technical data".
and a number come on.
There is an error in the hob.
Deactivate the hob and activate it
again after 30 seconds. If
comes on again, disconnect the hob
from the electrical supply. After 30
seconds, connect the hob again. If
the problem continues, speak to an
Authorised Service Centre.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes
on. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
9. TECHNICAL DATA
9.1 Rating plate
Model KITN323K
PNC 949 492 566 00
Typ 61 A2A 00 AA
220 - 240 V, 50 - 60 Hz
Induction 3.65 kW
Made in: Romania
Ser.Nr. .................
3.65 kW
ZANKER
98 ENGLISH