ZANKER KEV6340XXK, Руководство пользователя

Страница: 20 / 48

Problem Possible cause Remedy
The hob deactivates. You put something on the sensor
field .
Remove the object from the sensor
field.
Residual heat indicator does not
come on. The zone is not hot because it op-
erated only for a short time. If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
The sensor fields become hot. The cookware is too large or you
put it too near to the controls. Put large cookware on the rear
zones if possible.
comes on.
Automatic Switch Off operates. Deactivate the hob and activate it
again.
comes on.
The Child Safety Device function
operates. Refer to "Daily use" chapter.
and a number come on.
There is an error in the hob. Disconnect the hob from the electri-
cal supply for some time. Discon-
nect the fuse from the electrical sys-
tem of the house. Connect it again.
If comes on again, speak to an
Authorised Service Centre.
If you cannot find a solution...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
Give the data from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.
Make sure, you operated the hob correctly. If not the
servicing by a service technician or dealer will not be
free of charge, also during the warranty period. The
instructions about the Service Centre and conditions of
guarantee are in the guarantee booklet.
Installation
Warning! Refer to Safety chapters.
Before the installation
Before you install the hob, write down the information
bellow from the rating plate. The rating plate is on the
bottom of the hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble the hob
into correct built-in units and work surfaces that align to
the standards.
Connection cable
• The hob is supplied with a connection cable.
• To replace the damaged mains cable use the
following (or higher) mains cable type: H05V2V2-F T
min 90°C. Speak to your local Service Centre.
20