ZANKER KDT10042FK, Руководство пользователя

Страница: 16 / 44

• Pull out the upper basket.
• To disengage the spray arm from the basket, press the spray arm upwards in the direction indicated by the lower
arrow and simultaneously turn it clockwise.
• Wash the spray arm under running water. Use a thin pointed tool, e.g. toothpick, to remove particles of soil from
the holes.
• To engage again the spray arm to the basket, press the spray arm upwards in the direction indicated by the lower
arrow and simultaneously turn it counterclockwise until it locks into place.
External cleaning
• Clean the appliance with a moist soft cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive cleaning
pads or solvents.
Internal cleaning
• Carefully clean the appliance, including the rubber
gasket of the door, with a soft damp cloth.
• If you use short duration programmes regularly,
these can leave deposits of grease and limescale
inside the appliance. To prevent this, we
recommend running long duration programmes at
least twice a month.
• To maintain the performance of your appliance at its
best, we recommend using a specific cleaning
product for dishwashers (at least once a month).
Follow carefully the instructions on the packaging of
the product.
Troubleshooting
If the appliance does not start or it stops during
operation, before you contact an Authorised Service
Centre, check if you can solve the problem by yourself
with the help of the information in the table.
Warning! Repairs not properly done
may result in serious risk to the safety of
the user. Any repairs must be performed
by qualified personnel.
With some problems the end indicator flashes
intermittently indicating a malfunction.
The majority of problems that can occur can be
solved without the need to contact an Authorised
Service Centre.
Problem and alarm code Possible cause and solution
You cannot activate the appliance.
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no damaged fuse in the fuse box.
The programme does not start. • Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the end
of the countdown.
• The appliance has started the procedure to recharge the res-
in inside the water softener. The duration of the procedure is
approximately 5 minutes.
16