GSM REMOTE SWITCH GRG-01
INSTRUCTION MANUAL
The device is designed for
single-phase installation
and must be installed in
accordance with standards
valid in a particular country.
The device should be con-
nected according to the de-
tails included in this operat-
ing manual. Installation, connection and control
should be carried out by a qualified electrician
staff, who act in accordance with the service
manual and the device functions.
In case of casing dismantling an electric shock
may occur, and the guarantee is lost then. Be-
fore installation make sure the connection ca-
bles are not under voltage. The cruciform head
screwdriver 3,5 mm should be used to instal the
device. Improper transport, storage, and use of
the device influence its wrong functioning. It is
not advisable to instal the device in the following
cases: if any device part is missing or the device
is damaged or deformed. In case of improper
functioning of the device contact the producer.
CAUTION!
APPEARANCE
FEATURES
TECHNICAL DATA
DESCRIPTION
● remote control of electric device opera-
tion by means of commands (incoming
voice call, SMS massages) send from
a mobile phone,
● comfortable control of devices with dif-
ficult access (ventilation, heating, other),
● three operation modes (switching on,
switching off, restart - contact relay po-
sition change for adjusted time),
● easy mounting in 230V AC socket,
● operation is optically signalled (power
supply, relay status, GSM modem status),
● low power consumption, possibility of
constant work.
GSM remote switch is used to control
lighting, heating, etc., by means of GSM
mobile (SMS massage and/or incoming
mobile call). It is mounted in wall 230 V
AC socket and it has the possibility of
a remote restart of a connected device
(relay status changes according to the ad-
justed time). The device has a wide range
of protections as a list of numbers with
permission, access password, etc. Its op-
eration range is limited only by GSM net-
work infrastructure and it is not equipped
with operator’s lock (SIMLOCK).
GRG-01
Input rated voltage: 230 V AC
Optic signalling of input rated voltage: LED green diode
Nominal power consumption: 0,5 W / 2,5 W (GSM operation)
GSM frequency: 900/1800/1900 MHz
Operation range: limited by GSM network structure
Signalling of GSM status: LED two-coloured diode (green)
Optic signalling of relay status: LED two-coloured diode (red)
Output contacts’ parameters: 1NO 16A / 250V AC AC1 4000 VA
Ambient temperature range: -10 ÷ +55
o
C
Operating position: free
Casing mounting: 230 V AC socket
Casing protection degree: IP20 (EN 60529)
Protection level: II
Overvoltage category: II
Pollution degree: 2
Surge voltage: 1 kV (EN 61000-4-5)
Dimensions: 160 x 66 x 90 mm
Weight: 0,190 kg
Reference standard: EN 60950-1:2007
EN 55024:2000
EN 61000-4-4
The symbol means selective
collecting of electrical and electronic
equipment. It is forbidden to put the
used equipment together with
other waste.
Optic signalling of input voltage
Optic signalling of GSM network
status (green)
Receiver’s switch on optic signal (red)
Manual operation of the receiver
Programming push-button
Receiver’s socket
SIM card socket
Hole plug
Power supply pin
VER. 002_01.06.2011
SIM
card
ZAMEL
Sp. z o.o.
ul. Zielona 27, 43-200 Pszczyna, Poland
tel. +48 (32) 210 46 65, fax +48 (32) 210 80 04
www.zamelcet.com
, e-mail: [email protected]
