Zafferani Glas FLAT 4 fpe, Руководство пользователя

Страница: 32 / 61

ADVICE ON USE AND MAINTENANCE
In this chapter are the most important operation to do in order to use your grinding
machinev in the best way:

It is very important that the water tank (43), where is the pump (13), is changed every day
in order to have water always clean. It is a good rule to make the machine work ten
minutes every week-end without glass and with clean water. This operation let to clean all
the circuit from silicium residue.

In order to get a good polishing it is a good rule to refrigerate the polishing wheels with
running water connecting the valve (97) directly with your hydro network.

For a good working of the track it is necessary sometime to lubricate it by the grease
pump (92). Auctioning 5 or 6 times the lever of the pump with the track working you will
reduce completely the fretting of the guides of the track.

It could be happen that because of some mechanical bond the rubber plate for chaintrack
traction don't press the glass in a right way; if it is like this you have to adjust the hand-
wheel (1) on the right pressure and to move the red index to make it indicate the exact
thickness of the glass.

Your grinding machine is equipped with a system of stop and reversing of the track (60);
in case you use this opportunity you must consider that for your security it is necessary
that the glass goes out completely from the track to work again.

After months it may happen that because of some mechanical bond, a plate glass longer
then one meter and half is not worked in a right way. In this case, you must open the little
doors on the carters of the track, slacken the grub screw on the collet of the pinions,
slacken the jum nuts and screw lightly the screw (16) of 1/4 of turn from both the sides of
track. Now lock everything. This adjustment in case repeated will take back definitively
equilibrium of forces to chain conveyor sheet of glass.

Sometime it is a good rule to check that the track gears (30), (31), (32) are lubricated with
grease in a right way.

Sometime it is necessary to discharge the condense of the main pressure reducer (65); to
make this operation you have to close the valve of the air of your laboratory and the
discharge is automatic. It is necessary to check the level of the lubrication oil and in case
fill up.
ITA