15
DOC-USR-0034-08
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
Streaming RTP
6.6
Once you have UDP streaming running, it is relatively simple to change to RTP streaming. All that is
needed is a change of settings. To stream using RTP, complete the following steps:
Click on “Stop Encoder” to stop the current encoding session
(19)
Verify “Output Interface” is “Ethernet (VBR)”.
(20)
Change “Output Format” from “MPEG-2 TS” to “RTP”.
(21)
*Note:
Be sure not to select “MPEG-2 TS over RTP”.
Confirm that “Dest Port” is “8888”. This will be important for the VLC configuration.
(22)
Click on “Start Encoder” to start the RTP encoding session.
(23)
Figure 12 Changes to Encoding Parameters for RTP Encode
(3) Change “Output
Format” to “RTP”
(4) Set “Dest IP Address” to
multicast address or PC
IP address
(2) Confirm “Output
Interface” is set to
“Ethernet(VBR)”
(5) Confirm “Dest Port” is
“8888”
(5) Click “Start Encoder”
(1) If necessary, click “Stop Encoder”
