Z3-DME-20 User Instructions
DOC-USR-0180-05
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
16
6.4
Configure Encoder for Streaming UDP
Note:
Settings in the user interface cannot be changed if the unit is currently encoding.
(1)
If necessary, click the “Stop” button in the “Channel Controls” section of the CH1 tab or the “Stop
All” button in the lower right corner of any screen to stop any current encoding.
(2)
At the CH1 tab, verify the “Video Source” is set to “HDMI” using the dropdown menu.
(3)
Change “Output Resolution” to “3840x2160” or “Follow Input”.
(4)
Select the codec you would like to use for your encoding. Both H.265/HEVC and H.264/AVC are
supported. In the pictured example, verify “Video Codec” is set to “H265(HEVC)”.
(5)
Set “Output Format” to “UDP”.
(6)
You can set the “Dest Address” to:
(a)
the IP address of your PC that will be running the VLC media player (in the pictured
example, 192.168.0.6)
(b)
or to a multicast address (An example multicast address would be “225.1.2.3”. If you are
on a shared network, check with your Network Administrator.)
(7)
Make note of the value of “Dest Port” (This will be “8600” by default).
(8)
Click the “Start” button.
Figure 7 Channel 1 Tab - UDP
(5) Change
to “UDP”
(1) If necessary, click “Stop”
(8) Click “Start”
(2) Verify
Is “HDMI”
(3) Change to
“1920x1080” or
“Follow
input”
(4) Verify Codec
“H265(HEVC)”
(6) Set to PC
IP Address or
Multicast
Address
(7) Note value
