CONFIDENTIAL
DOC-USR-0010-09
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
16
7.5
Ensure Your PC has a Proper IP Address
(8)
(To be able to communicate with the board, the PC that you are communicating from needs to have
at least the same first two parts of the IP address. For example, if the board has an IP address of
192.168.81.68, your PC would need to have an address of 192.168.x.y, where x.y is anything but
81.68 (and not conflicting with whatever is on your current network). Ensure that this is the case.
If necessary, use the “P” and “Q” options in the RPS menu to modify the address / network mask
of the board to conform to your network. Note that the first two parts being the same are based
on a netmask of 255.255.0.0. If netmask were 255.255.255.0, then the first three parts of the IP
address would have to be the same.
After you are done, make note of the address you set your PC to. This will be important in the
streaming step.
7.6
Run the Web Interface to Configure Encode
(9)
In your PC, run a web browser (for best results, Z3 recommends FireFox or Chrome). In this browser,
type the IP address of the board noted in step (7) (for example, if the default value is used, it
would be http://192.168.81.68). After about 3 seconds, the Encoder Settings menu should come
up:
Figure 7 Encoder Settings Screen (Top Half)
